chrispeng [ad_1]
Please read the instructions carefully before proceeding.
1. Boot
1. Insert the power plug into the AC220V socket (make sure that the socket will not be overloaded).
2. Press the power switch, and the temperature display window shows the temperature of the machine at this time, which means that the power is normal.
2. Set temperature and holding time:
Different PVC (PET) cards and different laminated films require different temperature and holding time. Generally, the lamination temperature of PVC card and film is 90-120 degrees; the temperature of A4 lamination is 140-160 degrees, and the holding time is Usually 3-6 minutes.
Note: In general, the temperature should not exceed 150 degrees, otherwise it will cause deformation of the PVC card.
3. Place PVC (PET) printed matter and film:
1. Put a piece of “laminated plywood” into the “laminated pallet”, then put a layer of “with adhesive film” (note: the adhesive side with adhesive film is facing up), and then put a layer of “PVC printed matter” “, put another layer of “with adhesive film” (note: the adhesive side with adhesive film is facing down), and then put a “laminated plywood”…
2. Put the pallet with the PVC card and the film into the feed of the machine smoothly (make sure the pallet is in place).
3. The operation of A4 laminator is the same as above.
550)this.style.width=550;” border=0>
Fourth, pressurization
Operation steps: After the bracket is in place, turn the handwheel clockwise to compress the splint, and then press the afterburner bar before pressing the start button, and the machine will automatically heat up. When the set temperature is reached, the machine will Automatically count down according to the set time. When the countdown is “0”, the machine will automatically wind cooling, and when the temperature is cooled to 59 degrees, the machine will emit a “dididi, dididi……” alarm sound, indicating the layer The pressing work has been completed, turn the handwheel booster bar counterclockwise until the pallet can be taken out, and let it cool for a while after taking it out to avoid burning your hands.
Five, use and maintenance tips:
1. The laminated plywood should be kept clean at all times, and it can be scrubbed with a soft towel dipped in alcohol, and then dried with a clean towel.
2. After the machine has been stored for a long period of time, it must be checked and tested before starting.
3. Regularly add lubricating oil to the screw, column and other parts of the machine.
[ad_2]
