chrispeng [ad_1]
As people’s living standards continue to improve, the total number of cars owned has also begun to grow rapidly. How to carry out efficient, high-quality and intelligent management of the in and out of vehicles within a unit has become more and more important to various administrative departments, enterprises and institutions. The RFID-based remote vehicle access control system is at the forefront of the market and has high technical content. Through non-contact information collection and processing of long-distance fast-moving targets, rapid automatic identification and automatic management of in and out vehicles are realized, which is the best traditional management method. Upgrade options.
This system also solves the vehicle management problems faced by various units. It can be applied to the tracking control management of internal vehicles entering and exiting the unit gate, and it can also be applied to the fully automatic and unattended management of internal parking lots. , It is especially suitable for occasions such as the entrance and exit gates of military vehicles, school gates, and power company gates.
The following is a schematic diagram of two more typical application modes:
Mode 1: Single-channel access control: The channel width is 2-4 meters, and the card reading distance should be limited to less than 10 meters. You don’t need to stop if necessary. The speed of the vehicle should be controlled below 60 km/h. The reader is fixed on the side of the channel or suspended on the top of the channel with a stainless steel column. During installation, it can be adjusted to the best height and angle from the ground according to the actual situation on site.
Mode two, dual-channel access control: the total width of the channel is 4-6 meters, one entry and one exit, the card reading distance is limited to less than 10 meters, if necessary, you don’t need to stop, and the speed of the car should be controlled below 60 km/h. The reader is fixed on the side of the channel or suspended on the top of the channel with a stainless steel column. During installation, it can be adjusted to the best height and angle from the ground according to the actual situation on site.
[Program Features]
1. Long distance: easy to achieve within 10 meters of reading distance. Due to the actual requirements of vehicle access control, the card reading distance should not be too long. This solution does not need to be manually approached to swipe the card or to pass in a designated area to be recognized. Fully automatic recognition is realized, which can avoid problems such as the driver having to move the window close to the reader to swipe the card in bad weather. During peak hours, it can effectively alleviate the congestion problem caused by too many vehicles entering and leaving the warehouse and queuing credit cards.
2. Stable operation: The active card has a stable reading distance and is not easily affected by the surrounding environment. Moreover, the active card can effectively break through the shielding effect of the automobile’s explosion-proof metal mesh, and smoothly exchange data with the reader.
3. Supports high-speed mobile reading, and the moving speed of the identification card can reach 200 km/h.
4. High reliability, it can operate normally within the ambient temperature of -40℃-85℃, especially in the low temperature in the north and high temperature in the south, it has more advantages, and it can effectively resist dust and pollutants in the air.
5. High anti-interference: There are no special requirements for various interference sources on site, and the installation is convenient and simple.
6. Ultra-low power consumption: long service life, low average cost, safer and healthier for the human body, and no radiation damage.
[ad_2]
